7 Configuration level
54
Decimal place
dECP
0
1
2
no digit after the decimal point
one digit after the decimal point
two digits after the decimal point
If the value to be displayed cannot be
shown including the programmed decimal
point, the number of digits after the
decimal point are automatically reduced. If
subsequently the measured value contains
less digits, the reading appears with the
decimal point as programmed.
Function key
short
tAS
(Push time
< 2 seconds)
0
1
2
3
4
5
Function if the key is briefly pressed in the
normal display (max. two seconds)
no function
Starting the timer
Timer abort
Stop timer/continue timer run
Timer start/abort
Display timer value (manual)
Function key
long
tASt
(Push time
>2seconds)
0
1
2
3
4
5
Function if the key is pressed for more than
two seconds in the normal display
Change to manual mode
Starting the timer
Timer abort
Stop timer/continue timer run
Timer start/abort
Display timer value (manual)
Parameters Value/
Selection
Description
To Next Page
Loading...
