10
2 Mounting
2 Mounting
2.1 Installation instructions
WARNING!
The device is not designed for use in potentially explosive areas.
Explosion hazard.
Only deploy the device outside of potentially explosive areas.
Mounting site
The device is designed for installation in a panel cut-out within a closed switch cabinet. The front of the
device and housing have different protection types (see technical data).
Climatic conditions
The ambient temperature and the relative humidity at the mounting site must correspond to the technical
data. Aggressive gases and vapors have a negative effect on the operating life of the device. The mount-
ing site must be free from dust, powder, and other suspended solids.
Installation position
The device can be installed in any position.
The maximum admissible ambient temperature only applies for the installation with the display in a ver-
tical position.
Technical data
chapter 5 "Technical data", page 25
2.2 Cleaning
The front of the device (front foil) can be cleaned with standard detergents, rinsing and cleaning agents.
CAUTION!
The front of the device is not resistant to aggressive acids and lyes, scouring agents, and clean-
ing with a pressure cleaner.
Use of these media can cause damage.
Only clean the front of the device with suitable agents.
To Next Page
Loading...
Need help?
General
