31
4 Modbus protocol description
Error list: Keyboard and program lock
26 Keyboard locked
27 Programming locked
28 Write error in the ser. EEprom (Calib)
29 Hardware error: MANUAL + AUTO locked
30 Edit is inadmissible when the program is active
31 Copy is inadmissible when the program is active
32 MANUAL is inadmissible during AUTO lead time
33 Segment change Image update required
34 No DB number, image update by PLC
35 No DB number for process values of PLC
36 Printer loaded or not operational
37 Set point value 1 was not programmed
38 Configure printer (config./interface)
39 Only possible, when the device is in MANUAL mode
40 Self-optimization already running
41 Tme axis elapsed or not programmed
42 Time axis cannot be copied
43 Time axis not existing
44 Program change is locked
45 MANUAL mode locked
46 Program start locked
Error list: Interface processing
47 Incorrect response length
48 Timeout error (no response)
49 Error reported in telegram protocol
50 Checksum error
51 Parity error
52 Framing error
53 Interface buffer full
54 Address error (e.g. address does not exist)
Error code Description
To Next Page
Loading...
Need help?
General
