JUNCTEK
Represents the current actual time.
(4). Communication address
The communication address range is P01-P99, with P01 representing the
current communication address as P01, and the data viewed is for the P01
address.
(5). Communication signal indication
The current graphic represents that the display module and measurement
module are connected normally. When there is a red × in the graphic, it
indicates a communication interruption. Check whether the communication
address is correct, and then check whether the communication line is in good
contact.
(6). Power
Displays the actual measured power value in watts.
(7). Estimated time
Under current capacity and current discharge current/load power, shows how
long the device can still operate in the future. Under current capacity and
charging current, shows how long it will take to fully charge. When the current
changes from greater than 0A to 0A, the expected time will remain the same
for one minute before changing to "---h:--m." When the current changes from
0A to greater than 0A, the expected time will remain "---h:--m" for one minute
before updating to the calculated time.
(8). Data record
Displays the percentage of data storage space used with a progress bar.
When the progress bar is full, it means the data record storage space is full
and the data needs to be cleared, otherwise no data will be recorded. The
symbol "⏸" represents that data record is turned off, while "▶ " represents that
data record is turned on.
(9). Charging and discharging current direction
When the current color is green and the charging symbol ○＋ is displayed, it
indicates that the device is charging and the remaining capacity is increasing.
When the current color is blue and the discharging symbol is ○- displayed, it
indicates that the device is discharging and the remaining capacity is
decreasing.
(10). External temperature
Displays the ambient temperature, currently showing 13℃, which represents
the temperature of the environment where the external sensor is located.
(11). Battery remaining capacity graphical display
Displays the remaining battery capacity in a graphical and more intuitive way.
When on the main interface, the battery remaining capacity graphic displays in
red when the remaining capacity percentage is less than or equal to 20%, and
in green when the remaining capacity percentage is greater than 20%.
To Next Page
Loading...
General