Jung Home - Page 22

Parameters Setting options,
Default setting
Explanations
Colour temper-
ature range
(min-max) (only
with DALI in-
sert)
2000 ... 10000 K
Default setting:
2,700K ... 6,500 K
Defines the adjustable colour temperature
range. The minimum and maximum value
depend on the colour temperature range
of the lamp used and can be determined
on the basis of its data sheet or by means
of trial and error.
Switch-on col-
our temperature
(only with DALI
insert)
2000 ... 10000 K
Default setting: 2700 K
If a value is entered, the light is switched
to this colour temperature by a switch-on
command.
Last value:
When the light is switched on,
it is switched to the colour temperature
set last.
Warm dim-
ming** (only
with DALI in-
sert)
Off, on
Default setting: off
With the function switched on, the colour
temperature is changed based on a
stored curve when dimming the colour
temperature. The colour temperature of
the light is increased towards cool white
when dimming up and reduced towards
warm white when dimming down.
Hotel function** Off, on
Default setting: off
This convenience function prevents it
from becoming completely dark, for ex-
ample in hotel corridors, when the run-on
time expires or the light is switched off
manually. With the function switched on,
it switches between two brightness values
instead of between on and off. When
switched on, the light is switched to the
switch-on brightness and, when switched
off, to the brightness of the hotel function.
Hotel function
brightness**
5 ... 100%
Default setting: 20%
Defines the reduced brightness to which
the light is switched with activated hotel
function if the run-on time expires or the
light is switched off manually. The entry in
percent applies to the maximum bright-
ness of the dimming range.
Night light func-
tion**
Off, on
Default setting: off
This convenience function, which can be
used with a time program, can ensure
that the lighting in the corridor or bath-
room is switched on with less brightness
at night to prevent unpleasant glaring.
With the function switched on, the light is
switched by a switch-on command to the
set brightness of the night light function,
not to the switch-on brightness.
JUNG HOME push-button 1-gang, JUNG HOME push-button 2-gang
22 / 26
32405203 24.02.2023
J0082405203