To Next Page

To Previous Page

03.11 EN

A Correct Use and Application

1 General

The industrial truck described in the present operating instructions is designed for

lifting, lowering and transporting load units.

It must be used, operated and serviced in accordance with the present instructions.

Any other type of use is beyond the scope of application and can result in damage to

personnel, the industrial truck or property.

2 Correct application

NOTE

The maximum load and load distance are indicated on the load chart and must not be

exceeded.

The load must rest on the load handler or be lifted by an attachment approved by the

manufacturer.

The load must rest on the back of the fork carriage and centrally between the forks.

– Lifting and lowering of loads.

– Transporting lowered loads.

– Do not travel with a raised load (>500 mm).

– Do not carry or lift passengers.

– Do push or pull load units.

3 Approved application conditions

– Operation in industrial and commercial environments.

– Permissible temperature range 5°C to 40°C.

– Operation only on secure, level surfaces with sufficient capacity.

– Operation only on routes that are visible and approved by the proprietor.

– Negotiating inclines up to a maximum of 16 %.

– Do not negotiate inclines crosswise or at an angle. Transporting loads downhill.

– Operation in partially public traffic.

Z Special equipment and authorisation is required if the truck is to be used in extreme

conditions.

The truck is not authorised for use in areas at risk of explosion.