What to do if I see an error indication in display of Jungheinrich Trucks?
If you see an error on the display of your Jungheinrich Trucks, try this: Press the master EMERGENCY OFF switch or turn the key switch to the “0” position. Wait about 3 seconds, and then try the function you were trying to use again.
What to do if my Jungheinrich EFG-Vac 22 Trucks does not move?
If your Jungheinrich Truck doesn't move, here's what to check: * Ensure the battery plug is securely connected. * Make sure the master switch is released. * Verify the key switch is in the “I” position. * Check the battery charge and recharge if needed. * Inspect the fuses for any defects.
Why my Jungheinrich EFG-Vac 22 load cannot be lifted?
If the load cannot be lifted by your Jungheinrich Trucks, make sure of the following: 1. The truck is ready for operation (perform checks for the fault “Truck does not move”). 2. The hydraulic oil level is adequate. 3. The fuses are in good condition. 4. The battery has sufficient charge (recharge if necessary).
Specifications and performance data for the standard truck models.
Essential safety precautions for handling lead-acid batteries.
Key safety rules for operating the fork lift truck safely.
Instructions for proper use and maintenance of the safety restraint belt.
Detailed instructions and safety precautions for driving the truck.
Instructions for operating lifting mechanisms using the MULTIPILOT control.
Instructions for operating lifting mechanisms using the SOLOPILOT control.
Step-by-step guide for picking, transporting, and putting down loads.
Overview of servicing tasks and inspection intervals for the truck.
General| Brand | Jungheinrich |
|---|---|
| Model | EFG-Vac 22 |
| Category | Trucks |
| Language | English |
To Next Page