Jungheinrich EKS 110 - User Manual

Questions and Answers

J
joanne95Aug 3, 2025
What to do if my Jungheinrich Forklifts truck does not start?
- J
  jamesjacobAug 3, 2025
  If your Jungheinrich Forklift doesn't start, there are several potential causes: * The battery connector might not be connected. Ensure it is properly plugged in. * The main switch (Emergency Disconnect) may be depressed. Unlatch it. * The key switch could be set to “O”. Set it to “I.” * The battery charge might be too low. Check the charge and recharge if needed. * The gate may not be closed. Close the gates on either side of the operator platform. * The two-hand operation might not be pressed. Press the two-hand operation button. * The deadman switch may not be pressed. Press the deadman switch. * A fuse might be faulty. Check fuses 1F and F1.
E
Erika MartinAug 10, 2025
What to do if my Jungheinrich Forklifts load cannot be lifted?
- C
  Christian HutchinsonAug 10, 2025
  If your Jungheinrich Forklifts load cannot be lifted, consider these possibilities: * The truck might not be operational. Refer to the solutions for 'Truck does not start'. * The hydraulic oil level could be too low. Check the hydraulic oil level. * The gate may not be closed. Ensure the gates on either side of the operator platform are closed. * The two-hand operation might not be pressed. Press the two-hand operation button. * The battery discharge monitor may have switched off. Charge the battery. * A fuse might be faulty. Check fuses 2F1 and 2F2. * The load might be too heavy. Check the maximum capacity on the data plate.
H
Hannah WilsonAug 17, 2025
What to do if Jungheinrich Trucks does not move?
- G
  Gary PetersonAug 17, 2025
  If your Jungheinrich Truck isn't moving, several factors could be the cause. First, ensure the battery connector is securely connected. Check that the isolator (Emergency Stop) is not pressed (unlatch the main switch). Verify the key switch is in the "I" position, and the battery has sufficient charge. Make sure the side gates are fully closed, the two-hand operation button is pressed, and the foot switch is engaged. Finally, inspect fuses 1F and F1 for any faults.
A
angela57Aug 25, 2025
Why Jungheinrich Trucks load cannot be lifted?
- T
  Taylor AndersonAug 26, 2025
  If the load cannot be lifted on your Jungheinrich Truck, it could be due to several reasons. First, ensure the truck is operational by checking the points listed under 'Truck does not start'. Check the hydraulic oil level and make sure it is not too low. Verify that the side gates are closed and the two-hand operation button is pressed. Also, ensure the battery is charged, as the battery discharge monitor may have switched off the system. Check fuses 2F1 and 2F2. Finally, make sure that the load weight does not exceed the maximum capacity.