To Next Page

To Previous Page

03.09 EN

6.7 Restoring the truck to service after maintenance and repairs

After cleaning or repair work, the truck may only be restored to operation once the

following operations have been performed.

Procedure

• Clean the truck thoroughly.

• Lubricate the truck according to the lubrication schedule, (see "Lubrication Sched-

ule" on page 86).

• Clean the battery, grease the terminals and connect the battery.

• Charge the battery, (see "Charging the battery" on page 26).

• Check the transmission oil for condensation water and replace if necessary.

• Check the hydraulic oil for condensation water and replace if necessary.

Z The manufacturer's customer service department is specially trained to carry out

these operations.

WARNING!

Faulty brakes can cause accidents

As soon as the truck has been started, test the brakes several times.

XReport any defects immediately to your supervisor.

XTag out and decommission a faulty lift truck.

XOnly return the truck to service when you have identified and rectified the fault.

• Start up the truck, (see "Starting up the truck" on page 39).

Z If there are switching problems in the electrical system, apply contact spray to the

exposed contacts and remove any oxide layers on the contacts of the controls by

applying them repeatedly.