Jungheinrich EKS 110 User Manual

9
03.09 EN
B Truck Description
1 Application
The EKS 110 is an electric vertical stockpicker. The truck is designed to transport and
pick goods on level surfaces in accordance with DIN 15185.
It is designed to lift open bottom, cross-board pallets and roll cages. The truck is not
suitable for stacking pallets in rack systems. The driver's cab is raised with the load
handler so that the compartment levels to be operated are visible and within easy
reach.
The rack systems must be set up for the EKS 110. The safety distances stipulated by
the manufacturer (e.g. EN 1726-2 item 7.3.2) must be observed.
There must be a minimum safety distance between the rack and the truck of
– 100 mm for rail guided trucks and
– 125 mm for wire-guided trucks.
The ground surface must comply with DIN 15185. Guide rails must be provided in the
narrow aisles for the rail guidance system. Vulkollan guide wheels attached to the
truck chassis guide the truck between the guide rails.
The truck is fitted as standard with a simplex mast (E mast) or a duplex mast (ZZ mast)
(lift heights (see "Technical Specifications" on page 12)). Auxiliary lift is optionally
available, which allows the forks to be raised a further 800 mm.
2 Travel direction definition
The following determinations have been made for travel direction specification:
Left
Right
Drive
direction
Load
direction
9
03.09 EN
B Truck Description
1 Application
The EKS 110 is an electric vertical stockpicker. The truck is designed to transport and
pick goods on level surfaces in accordance with DIN 15185.
It is designed to lift open bottom, cross-board pallets and roll cages. The truck is not
suitable for stacking pallets in rack systems. The driver's cab is raised with the load
handler so that the compartment levels to be operated are visible and within easy
reach.
The rack systems must be set up for the EKS 110. The safety distances stipulated by
the manufacturer (e.g. EN 1726-2 item 7.3.2) must be observed.
There must be a minimum safety distance between the rack and the truck of
– 100 mm for rail guided trucks and
– 125 mm for wire-guided trucks.
The ground surface must comply with DIN 15185. Guide rails must be provided in the
narrow aisles for the rail guidance system. Vulkollan guide wheels attached to the
truck chassis guide the truck between the guide rails.
The truck is fitted as standard with a simplex mast (E mast) or a duplex mast (ZZ mast)
(lift heights (see "Technical Specifications" on page 12)). Auxiliary lift is optionally
available, which allows the forks to be raised a further 800 mm.
2 Travel direction definition
The following determinations have been made for travel direction specification:
Left
Right
Drive
direction
Load
direction

Jungheinrich EKS 110 Specifications

General

Brand	Jungheinrich
Model	EKS 110
Category	Trucks
Language	English