Error displays adding a user code
For the following events the LED (76) flashes red:
Cause Remedy
– The user code entered is
not the same length as the
master code
– Switch off the truck, see page 115.
– Repeat the entry, making sure that the master
code is the same length as the user code.
– New user code is already
occupied by a master code
– Switch off the truck, see page 115.
– Choose a different user code, see page 118.
– The newly entered user
codes do not match
– Switch off the truck, see page 115.
– Add the user code again, see page 118.
– Code log full.
– Switch off the truck, see page 115.
– Delete individual user codes, see page 122.
– Delete all user codes, see page 124.
119
04.19 en-GB
To Next Page
Loading...
