Error displays deleting individual user codes
For the following events the LED (76) flashes red:
Cause Remedy
– The user code entered is
not the same length as the
master code
– Switch off the truck, see page 115.
– Repeat the entry, making sure that the master
code is the same length as the user code.
– Tried to delete an operator
code that does not exist.
– Switch off the truck, see page 115.
– Check the user code entered.
– The user codes to be
changed do not match
– Switch off the truck, see page 115.
– Delete the user code again, see page 122.
123
04.19 en-GB
To Next Page
Loading...
