8.1.11 Assigning the travel program
The travel programs are fixed to the user code and can be released or blocked with
a configuration code. The configuration code can also be used to assign a starting
travel program to each user code.
Z
The starting travel program is the travel program that is activated when the truck is
switched on and is displayed by the (72,73,74) LEDs.
LED (72) lit = travel program 1 activated
LED (73) lit = travel program 2 activated
LED (74) lit = travel program 3 activated
The configuration code is four-digit and is comprised as follows:
– 1st digit: Specifies the authorisation for travel program 1:
– 2nd digit: Specifies the authorisation for travel program 2:
– 3rd digit: Specifies the authorisation for travel program 3:
– 4. digit: Specifying the starting travel program
When you add or change a user code all travel programs are enabled, the starting
travel program is travel program 2.
128
04.19 en-GB
To Next Page
Loading...
