Jungheinrich ERE Series - Operating Without Drive System

C 3
0108.GB
4 Operating the truck without its own drive system
F
This operating mode is not permitted when negotiating inclines and gradients.
If the truck has to be moved after a failure has rendered it immobile, proceed as
follows:
– Set the key switch OFF and remove the key.
– Disconnect the battery.
– Prevent the truck from rolling away.
– Open and put away the front cover (refer to chapter F).
– Pull up the anchor plate (4) by screwing in two M5x16 screws as far as the stop.
The brake has now been released and the truck can be moved.
F
On reaching your destination, ensure that the brake is restored to its initial state. The
truck must never be parked with the brake released.
– Remove the screws.
The brake is now applied again.
– Refit the front cover.
4
C 3
0108.GB
4 Operating the truck without its own drive system
F
This operating mode is not permitted when negotiating inclines and gradients.
If the truck has to be moved after a failure has rendered it immobile, proceed as
follows:
– Set the key switch OFF and remove the key.
– Disconnect the battery.
– Prevent the truck from rolling away.
– Open and put away the front cover (refer to chapter F).
– Pull up the anchor plate (4) by screwing in two M5x16 screws as far as the stop.
The brake has now been released and the truck can be moved.
F
On reaching your destination, ensure that the brake is restored to its initial state. The
truck must never be parked with the brake released.
– Remove the screws.
The brake is now applied again.
– Refit the front cover.
4