Jungheinrich ERE Series - Replacing the Drive Wheel; Checking Hydraulic Oil Level

F 9
0709.GB
6.4 Replacing the drive wheel
Z
The drive wheel must only be replaced by authorised service personnel.
6.5 Checking the hydraulic oil level
– Prepare the truck for maintenance
and repairs (see section 6.1).
– Opening the front panel (see Section
6.3).
– Check hydraulic oil level in hydraulic
reservoir (7).
Z
There are markings (6) on the hydraulic
reservoir. The oil level should lie
between the "max" and "min" markings
when the forks are lowered.
If necessary, add hydraulic oil of the
correct grade up to the "max" mark.
(for hydraulic oil specification, see
Section 5).
min
max
7
6
F 9
0709.GB
6.4 Replacing the drive wheel
Z
The drive wheel must only be replaced by authorised service personnel.
6.5 Checking the hydraulic oil level
– Prepare the truck for maintenance
and repairs (see section 6.1).
– Opening the front panel (see Section
6.3).
– Check hydraulic oil level in hydraulic
reservoir (7).
Z
There are markings (6) on the hydraulic
reservoir. The oil level should lie
between the "max" and "min" markings
when the forks are lowered.
If necessary, add hydraulic oil of the
correct grade up to the "max" mark.
(for hydraulic oil specification, see
Section 5).
min
max
7
6