Jungheinrich ERE Series - Page 43

1113.GB
E 14
Starting the truck for the first time
When the main switch is turned on the LED (16) goes red.
When you enter the correct operator code (factory setting 2-5-8-0) the LED (16) turns
green.
If the wrong code is entered LED (16) flashes red for two seconds. The correct code
can then be entered.
Z
The Set key (17) has no function in operating mode
Switching off
To switch the truck off, press the o key (21).
Z
The truck can switch off automatically after a
pre-determined time. To do this, the corre-
sponding code lock parameter must be set
(refer to section 5.4).
123
456
789
0
Set
18
17
16
21
2019
1113.GB
E 14
Starting the truck for the first time
When the main switch is turned on the LED (16) goes red.
When you enter the correct operator code (factory setting 2-5-8-0) the LED (16) turns
green.
If the wrong code is entered LED (16) flashes red for two seconds. The correct code
can then be entered.
Z
The Set key (17) has no function in operating mode
Switching off
To switch the truck off, press the o key (21).
Z
The truck can switch off automatically after a
pre-determined time. To do this, the corre-
sponding code lock parameter must be set
(refer to section 5.4).
123
456
789
0
Set
18
17
16
21
2019