133
08.11 EN
Impact sensor
Sideshifter
Seat heating
Road traffic approval (StVZO)
Telescopic forks
Electrical System W A B C
Check impact sensor is secure and check for damage. t
Hydraulic operations W A B C
Check attachment is properly secured to the truck and the
supporting elements.
t
Test hose reel and check for leaks and damage. t
Attachment:
check bearing points, guides and stops for wear and damage,
grease and clean these components.
t
Check cylinder piston rods and bushings. t
Test sideshifter, check settings and check for damage. t
Test operation and setting of the attachment.
Check attachment for damage.
t
Check cylinder seals. t
Check sliding blocks are complete. t
Check axial play of the front and rear rollers and adjust if necessary. t
Check hydraulic ports and tighten if necessary. t
Attachment:
Clean and lubricate.
t
Electrical System W A B C
Check electric wiring for damage [insulation damage, connections].
Make sure wire connections are secure.
t
Electrical System W A B C
Test lighting. t
Hydraulic operations W A B C
Attachment:
Clean and lubricate.
t
Check hydraulic ports and tighten if necessary. t
Check cylinder seals. t
To Next Page
Loading...
Need help?
General
