08.11 EN
66
Driver’s seat with pneumatic weight adjustment
(MSG 75) (
o
)
Procedure
• Pull the weight adjustment lever (98) up to set the seat
to a higher weight.
• Push the weight adjustment lever (98) down to set the
seat to a lower weight.
The driver's weight is correct when the arrow is in the middle of the display window
(99).
Adjusting the seat position
CAUTION!
An unsecured driver's seat can cause injury
An unsecured driver's seat can slide out of its guide during travel, resulting in
accidents.
XThe driver's seat must be locked in position.
XDo not adjust the driver’s seat while travelling.
Procedure
• Sit on the driver’s seat.
• Pull up the driver’s seat locking lever100 in the direction of the arrow.
• Push the driver’s seat forwards or backwards to the desired position
• Engage the driver’s seat locking lever (100) in position.
The seat position is now correctly set.
Adjusting the lumbar vertebrae
support (
o
)
Procedure
• Turn the hand wheel (102) to the
required position.
Position 0 = no warping in lumbar
vertebrae area.
Position 1 = increasing warping in
upper lumbar vertebrae area.
Position 2 = increasing warping in lower
lumbar vertebrae area.
The lumbar vertebrae support is now set.
98
98
101100
99
102
To Next Page
Loading...
Need help?
General
