Quick Start Guide
EX4600
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 6
Step 3: Keep Going | 9
Step 1: Begin
IN THIS SECTION
Install the Power Supplies (If Not Already Installed) | 2
Install the Fan Modules (If Not Already Installed) | 3
Mount the EX4600 | 3
Connect Power to the EX4600 | 5
To install and perform initial configuration of a Juniper Networks EX4600 Ethernet Switch, you need:
•
Electrostatic discharge (ESD) grounding strap (not provided)
•
One pair of side mounting-rails (provided)
•
One pair of rear mounting-blades (provided)
•
Twelve screws to secure the mounting-rails and mounting-blades to the chassis (provided)
•
Eight screws to secure the chassis and mounting-blades to the rack (not provided)
•
Screwdriver appropriate for your rack-mounting screws (not provided)
•
Two power cords with plugs appropriate for your geographical location (provided, for all EX4600 switches except the
EX4600-40F-S switch.
To Next Page
General
