Need help?Do you have a question about the Juniper EX4200 Series and is the answer not in the manual?
General| Switching Capacity | 128 Gbps |
|---|---|
| Ports | 24 or 48 10/100/1000BASE-T ports |
| Virtual Chassis | Up to 10 switches |
| Layer 3 Routing | Yes |
| Maximum VLANs | 4096 |
| DRAM | 1 GB |
| Flash Memory | 1 GB |
| Humidity | 5% to 90% non-condensing |
| Power Supply | AC or DC options |
| MAC Address Table Size | 32, 000 entries |
| Operating Temperature | 0°C to 45°C |
| Layer 2 Features | VLAN, STP, RSTP, MSTP, LACP |
| Management | CLI, Web UI, SNMP |
| Storage Temperature | -40°C to 70°C |
| Input Voltage | AC: 100-240V; DC: -48V |
Overview of the hardware features and capabilities of the EX3200 and EX4200 switches.
Explains how EX4200 switches interconnect to form a unified Virtual Chassis.
Provides an overview of the steps for installing and connecting the switch.
Step-by-step procedure for installing an AC or DC power supply into the switch.
Steps for connecting a Virtual Chassis cable to the VCP ports on an EX4200 switch.
Instructions on connecting the switch chassis to earth ground for safety and EMI compliance.
Procedure for connecting AC power to the switch, including power supply and cord details.
Steps for connecting DC power to the switch, including wiring sequence and terminals.
Step-by-step guide for configuring the switch using the Command Line Interface (CLI).
Step-by-step guide for configuring the switch using the J-Web graphical interface.
Essential safety guidelines to ensure user safety and protect the switch from damage.
Instruction to read installation procedures before connecting the switch to power.
Emphasizes the importance of grounding the switch chassis for safety.
Broad electrical safety guidelines applicable to all EX Series switches.
Specific safety guidelines for switches powered by AC sources.
Specific safety guidelines for switches powered by DC sources.
To Next Page