Juniper EX4200 Series User Manual

a member ID in the range from 0 through 9 because there was already at least one
member of the Virtual Chassis configuration. The member ID is automatically assigned
to the new member switch's serial number in the configuration file.
Related Topics • Example: Expanding a Virtual Chassis Configuration in a Single Wiring Closet
• Example: Setting Up a Multimember Virtual Chassis Access Switch with a Default
Configuration
• Example: Configuring a Virtual Chassis Interconnected Across Multiple Wiring Closets
• Example: Configuring a Virtual Chassis Using a Preprovisioned Configuration File
• Example: Configuring Automatic Software Update on Virtual Chassis Member Switches
• Monitoring Virtual Chassis Configuration Status and Statistics
• Replacing a Member Switch of a Virtual Chassis Configuration (CLI Procedure) on
page 183
• Reverting to the Default Factory Configuration for the EX Series Switch
113Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Planning the Virtual Chassis

Juniper EX4200 Series Specifications

General

Switching Capacity	128 Gbps
Ports	24 or 48 10/100/1000BASE-T ports
Virtual Chassis	Up to 10 switches
Layer 3 Routing	Yes
Maximum VLANs	4096
DRAM	1 GB
Flash Memory	1 GB
Humidity	5% to 90% non-condensing
Power Supply	AC or DC options
MAC Address Table Size	32, 000 entries
Operating Temperature	0°C to 45°C
Layer 2 Features	VLAN, STP, RSTP, MSTP, LACP
Management	CLI, Web UI, SNMP
Storage Temperature	-40°C to 70°C
Input Voltage	AC: 100-240V; DC: -48V