Need help?Do you have a question about the Juniper EX4600 Series and is the answer not in the manual?
General| Product Series | EX4600 |
|---|---|
| 10GbE ports | 24 or 48 |
| Cooling | Front-to-back or back-to-front airflow |
| Rack Units | 1 U |
| Virtual Chassis | Up to 10 members |
| MAC address table size | 288, 000 entries |
| Memory | 8 GB DRAM |
| Layer 3 Routing | Yes |
| AC Power Input | 100-240V AC |
| Ports | 24 or 48 x 10GbE ports |
| 40GbE ports | 4 |
| 100GbE ports | 0 |
| Power Supply | Dual redundant, hot-swappable AC or DC |
| Jumbo frames | 9216 bytes |
| Operating temperature | 0°C to 45°C |
| Input voltage | 100-240 VAC, -40 to -72 VDC |
| Operating relative humidity | 5% to 90% noncondensing |
| Fans | Redundant |
| JUNOS OS | Junos OS |
| Storage | 16 GB flash |
| DC Power Input | -40 to -72 VDC |
Overview of EX4600 switch hardware features and deployment.
Details on the EX4600-40F model, its CPU, memory, and storage.
Checklist for site preparation tasks including environment, power, and rack requirements.
Guidelines for acceptable operating environment and preventing equipment failures.
Factors to consider when planning electrical wiring at the site.
Required environmental conditions for normal switch operation.
Guidelines to ensure safety and protect the device from damage during operation.
Explains the different levels of safety warnings used in the documentation.
Procedures for protecting people and equipment in the event of a fire emergency.
Warning that only trained and qualified personnel should install or replace the device.
Specific warning statement for Norway and Sweden regarding electrical safety.
Procedure for mounting and connecting the EX4600 switch.
Steps to unpack the EX4600 switch and verify components.
Instructions for mounting the switch in a rack or cabinet using the provided kit.
Procedure to connect the EX4600 switch to earth ground for safety.
Steps to connect AC power to the EX4600 switch.
Steps to connect DC power to the EX4600 switch.
Procedure to connect the device to a management console.
Connecting the switch to a network for out-of-band management.
Cabling EX4600 switches together to create a Virtual Chassis.
Overview of installing and removing hardware components.
Procedure for installing a power supply in the EX4600 switch.
Procedure for removing a power supply from the EX4600 switch.
Procedure for installing an expansion module in the EX4600 switch.
Procedure for removing an expansion module from the EX4600 switch.
Procedure for installing a fan module in the EX4600 switch.
Procedure for removing a fan module from the EX4600 switch.
Procedure for removing a transceiver from an EX Series switch.
Procedure for installing a transceiver in an EX Series switch.
Procedure for disconnecting a fiber-optic cable.
Procedure for connecting a fiber-optic cable.
Guidelines for maintaining fiber-optic cables.
Description of chassis status LEDs and their meanings.
Description of management port LEDs and their meanings.
Description of access and uplink port LEDs and their meanings.
Description of fan module LEDs and their meanings.
Description of AC power supply LEDs and their meanings.
Description of DC power supply LEDs and their meanings.
Procedure to create an emergency boot device.
Procedure to perform a recovery installation of Junos OS.
Procedure for returning hardware for repair or replacement.
How to find the serial number for return and support purposes.
Instructions for packing the switch or component for shipping.
How to contact support for RMA.
Explanation of alarm types and severity levels.
Configuration of interface alarms for link-down conditions.
To Next Page