Figure 18: Attaching Mounting Rails to the EX4600
4. Attach the mounting rail to the switch using the mounting screws (and cage nuts and
washers if your rack requires them). Tighten the screws.
5. Repeats steps 4 and 5 on the opposite side of the switch.
6. Have one person grasp both sides of the switch, lift it, and position it in the rack so
that the front bracket is aligned with the rack holes.
7. Have a second person secure the front of the switch to the rack using four mounting
screws (and cage nuts and washers if your rack requires them.) Tighten the screws.
See Figure 19 on page 143 for examples of connecting the mounting rails and blades.
Figure 19: Attach EX4600 Switch to Rack
2—1— Front bracketMounting rail
8. Continue to support the switch while sliding the rear mounting-blades into the channel
of the side mounting-rails and securing the blades to the rack. Use the four mounting
screws (and cage nuts and washers if your rack requires them) to attach each blade
to the rack. Tighten the screws. See Figure 20 on page 144.
143Copyright © 2014, Juniper Networks, Inc.
Chapter 16: Installing the EX4600 Device
To Next Page
Loading...
