Juniper EX4600 Series

CHAPTER 16
Installing the EX4600 Device
•
Installing and Connecting an EX4600 Switch on page 139
•
Unpacking an EX4600 Switch on page 140
•
Mounting an EX4600 Switch in a Rack or Cabinet on page 141
Installing and Connecting an EX4600 Switch
You can mount an EX4600 switch:
•
Flush with the front of a 19-in. four-post rack. Use the standard mounting brackets
provided with the switch for this configuration.
•
Recessed 2 in. (5 cm) from the front of a 19-in. four-post rack. Use the extension bracket
provided in the standard mounting kit for this configuration. Recessed mounting is
primarily used in enclosed cabinets.
To install and connect an EX4600 switch:
1. Follow the instructions in “Unpacking an EX4600 Switch” on page 140.
2. Determine how the switch is to be mounted.
Flush or recessed mounted in a rack or cabinet, see “Mounting an EX4600 Switch in
a Rack or Cabinet” on page 141.
3. Follow the instructions in:
a. Connecting Earth Ground to an EX4600 Switch on page 146
b. Connecting DC Power to an EX4600 Switch on page 149
c. Configuring an EX4600 Switch on page 159
Related
Documentation
Rack Requirements for an EX4600 Switch on page 39•
• Cabinet Requirements for an EX4600 Switch on page 40
• Clearance Requirements for Airflowand Hardware Maintenance for an EX4600 Switch
on page 41
139Copyright © 2014, Juniper Networks, Inc.