Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for the EX4600 Switch
This topic describes the specifications for the SFP, SFP+, and QSFP+ transceivers used
in the EX4600 switch.
The optical transceivers installed in an EX4600 switch support digital optical monitoring
(DOM): you can view the diagnostic details for these transceivers by issuing the operational
mode CLI command show interfaces diagnostics optics. The command does not give any
output for copper transceivers or transceivers not purchased from Juniper Networks.
The three tables in this topic describe the optical interface support over single-mode
fiber-optic (SMF) and multimodefiber-optic (MMF) cables and copper interface support
over four-pair, Category 5 shielded twisted-pair cables:
•
Table 20 on page 50—Copper interface support and optical interface support for
Gigabit Ethernet SFP transceivers.
•
Table 21 on page 53—Optical interface support for 10-Gigabit Ethernet SFP+
transceivers.
•
Table 22 on page 58—Optical interface support for 40-Gigabit Ethernet QSFP+
transceivers.
NOTE: If you are using the QFX-QSFP-40G-ESR4 transceiver in a QSFP+
port and have configuredthe port to operate asmultiple 10-Gigabit Ethernet
interfaces, you can use a fiber breakout cable to distribute the interfaces
to up to four 10GBASE-SR SFP+ transceivers. Juniper Networks does not
sell fiber breakout cables.
49Copyright © 2014, Juniper Networks, Inc.
Chapter 8: Port and Interface Specifications
* Optics, Fans and Power supply sold separately for EX4600-40F-S.