eléctricos, e com quaisquer práticas comuns que possam prevenir possíveis
acidentes.
¡Atención! Este símbolo de aviso significa peligro. Existe riesgo para su
integridad física. Antes de manipular cualquier equipo, considerar los riesgos
que entraña la corriente eléctrica y familiarizarse con los procedimientos
estándar de prevención de accidentes.
Varning! Denna varningssymbol signalerar fara. Du befinner dig i en situation
som kan leda till personskada. Innan du utför arbete på någon utrustning
måste du vara medveten om farorna med elkretsar och känna till vanligt
förfarande för att förebygga skador.
Related
Documentation
General Safety Guidelines and Warnings on page 91•
• Installation Instructions Warning on page 103
• Maintenance and Operational Safety Guidelines and Warnings on page 113
• Grounded Equipment Warning on page 112
• Laser and LED Safety Guidelines and Warnings for EX Series Switches on page 98
• Laser and LED Safety Guidelines and Warnings for the QFX Series
• Warning Statement for Norway and Sweden on page 96
Fire Safety Requirements
This topic applies to hardware devices in the EX Series product family, which includes
switches, the EX Series Redundant Power System (RPS), and the XRE200 External
Routing Engine.
This topic also applies to hardware devices in the QFX Series.
In the event of a fire emergency involving switches and other network equipment, the
safety of people is the primary concern. You should establish procedures for protecting
people in the event of a fire emergency, provide safety training, and properly provision
fire-control equipment and fire extinguishers.
In addition, you should establish procedures to protect your equipment in the event of a
fire emergency. Juniper Networks products should be installed in an environment suitable
for electronic equipment. We recommend that fire suppression equipment be available
in the event of a fire in the vicinity of the equipment and that all local fire, safety, and
electricalcodes and ordinancesbe observed when you install and operate your equipment.
Fire Suppression
In the event of an electrical hazard or an electrical fire, you should first turn power off to
the equipment at the source.Then use a Type C fire extinguisher, which uses noncorrosive
fire retardants, to extinguish the fire.
Copyright © 2014, Juniper Networks, Inc.94
EX4600 Switch Hardware Guide
To Next Page
Loading...
Need help?
General
