Juniper EX9214

Quick Start Guide
EX9214
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 9
Step 3: Keep Going | 12
Step 1: Begin
IN THIS SECTION
Install the Large Mounting Shelf in an Open-Frame Rack | 3
Mount the EX9214 | 4
Connect Power to the EX9214 | 5
To install and perform initial configuration of a Juniper Networks EX9214 Ethernet Switch, you need:
•
One large mounting shelf (provided)
•
Mounting screws. The following mounting screws are provided:
•
Eight 12-24, ½-in. screws to mount the large mounting shelf on the rack
•
Sixteen 10-32, ½-in. screws to mount the switch on the rack
•
Two ¼-20, ½-in. screws to attach the grounding cable lug to the switch
•
Phillips (+) screwdrivers, numbers 1 and 2 (not provided)
•
7/16-in. (11-mm) torque-controlled driver or socket wrench (not provided)
•
One mechanical lift (not provided)

Juniper EX9214 Specifications

General

Model	EX9214
Product Series	EX9200
Total Slots	14
Power Supply	AC or DC
Maximum Virtual LANs	4096
Management	Junos CLI
Uplink Port	10GbE, 40GbE
MAC Address Table Size	288, 000
Jumbo Frame Support	Yes
Input Voltage	100-240VAC
Weight	175 lb (79.4 kg) (fully configured)
Form Factor	Chassis-based
Redundancy	Yes (Power and Fan)

Summary

Install the Large Mounting Shelf in an Open-Frame Rack

Mount the EX9214

Connect Power to the EX9214

Connecting EX9214 to AC power

Detailed steps for connecting the switch to AC power sources for operation.

Connecting EX9214 to DC power

Detailed steps for connecting the switch to DC power sources for operation.

Step 2: Up and Running

Set Parameter Values

Configure console server or PC settings for switch management and connectivity.

Perform the Initial Configuration

Guide to configuring software, user accounts, hostname, and network settings via CLI.

Step 3: Keep Going

Safety Warnings Summary

Overview of essential safety precautions for handling and installing the switch.

Contacting Juniper Networks

Information on how to obtain technical support from Juniper Networks.