Quick Start Guide
EX9208
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 7
Step 3: Keep Going | 9
Step 1: Begin
IN THIS SECTION
Install the Mounting Shelf in a Rack | 2
Mount the EX9208 | 3
Connect Power to the Switch | 4
To install and perform initial configuration of a Juniper Networks EX9208 Ethernet Switch, you need:
•
One small mounting shelf and 22 mounting screws (provided)
•
Phillips (+) screwdrivers, numbers 1 and 2 (not provided)
•
7/16-in. (11-mm) torque-controlled driver or socket wrench (not provided)
•
One mechanical lift (optional, not provided)
•
Electrostatic discharge (ESD) wrist strap with cable (provided)
•
2.5-mm flat-blade (–) screwdriver (not provided)
•
Power cord with a plug appropriate for your geographical location for each power supply (not provided)
•
Ethernet cable with an RJ-45 connector attached (provided)
To Next Page
Need help?
General
