What to do if my Juniper Switch has excessive component temperature?
If your Juniper Switch components are overheating, make sure the switch has enough ventilation and that there are no obstructions blocking airflow.
What to do if a Juniper Switch has a media failure?
If your Juniper Switch is experiencing a media failure, inspect the media connections and replace any faulty cables.
General| Throughput | 77 Mpps |
|---|---|
| MAC address table | 8000 entries |
| Jumbo frames support | Yes |
| Number of VLANs | 1024 |
| Networking standards | - |
| Switch type | Managed |
| SFP module slots quantity | 4 |
| Installed SFP modules quantity | 0 |
| Basic switching RJ-45 Ethernet ports quantity | 48 |
| Stackable | No |
| Product color | Black |
| Power consumption (typical) | 100 W |
| Operating altitude | 0 - 3048 m |
| Non-operating altitude | 0 - 4877 m |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 0 - 45 °C |
| Storage relative humidity (H-H) | 0 - 95 % |
| Operating relative humidity (H-H) | 10 - 85 % |
Weight and Dimensions| Depth | 254 mm |
|---|---|
| Width | 441 mm |
| Height | 43 mm |
| Weight | 3600 g |
Details on different EX2200 switch models, their port configurations, and PoE support.
Information on the built-in power supply for EX2200 switches and power consumption.
Lists supported optical and copper interface SFP transceivers for EX2200 switches.
A checklist of tasks for preparing a site for EX2200 switch installation.
Provides a comprehensive guide for installing the EX2200 switch.
Provides a step-by-step guide for installing and connecting an EX2200 switch.
Procedures for connecting the switch to power, network, and console.
Explains how to connect the switch to earth ground for safety and proper operation.
Instructions for connecting AC power to the EX2200 switch.
Steps for connecting DC power to the EX2200 switch.
Guides on performing the initial configuration of EX Series switches.
Step-by-step guide for connecting and configuring EX Series switches using the CLI.
Guide for connecting and configuring EX Series switches using the J-Web interface.
Essential safety guidelines and warnings for handling hardware devices.
Essential safety guidelines and warnings for handling hardware devices.
Emphasizes that only trained and qualified personnel should install or replace devices.
Safety guidelines and warnings related to radiation and laser hazards.
Safety guidelines and warnings for working with laser and LED components in switches.
Warning against staring into laser beams or viewing them directly with optical instruments.
Safety information related to installation and maintenance procedures.
Reminder to read installation instructions before connecting devices to power.
Precautions to prevent bodily injury when mounting devices in racks or cabinets.
Emphasizes the importance of grounding equipment during normal use.
Safety information related to power supply and electrical connections.
General guidelines and warnings related to power and electrical safety.
Guidelines to minimize potential ESD damage to sensitive components.
Warning to unplug power cords before working on the switch or power supplies.
Warning to ensure DC power is removed before performing any DC power procedures.
Requirements and warnings related to DC power grounding connections.
Critical information on the correct DC power wiring sequence for safe connections.
Steps to follow in case of an electrical accident involving injury.
Procedures for returning hardware for repair, replacement, or shipping.
To Next Page
