EasyManuals Logo

Juniper EX2200 User Manual

Juniper EX2200
238 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
Table 21: Site Electrical Wiring Guidelines
GuidelinesSite Wiring Factor
If your site experiences any of the following problems, consult experts in
electrical surge suppression and shielding:
Improperly installed wires cause radio frequency interference (RFI).
Damage from lightning strikes occurs when wires exceedrecommended
distances or pass between buildings.
Electromagneticpulses (EMPs) caused by lightning damage unshielded
conductors and electronic devices.
Signaling limitations
To reduce or eliminate RFI from your site wiring, do the following:
Use a twisted-pair cable with a good distribution of grounding
conductors.
If you must exceed the recommended distances, use a high-quality
twisted-pair cable with one ground conductor for each data signal when
applicable.
Radio frequency
interference
If your site is susceptible to problems with electromagnetic compatibility
(EMC), particularly from lightning or radio transmitters, seek expert advice.
Some of the problems caused by strong sources of electromagnetic
interference (EMI) are:
Destruction of the signal drivers and receivers in the switch
Electrical hazards as a result of power surges conducted over the lines
into the equipment
Electromagnetic
compatibility
Related
Documentation
General Safety Guidelines and Warnings on page 169
General Electrical Safety Guidelines and Warnings on page 197
Prevention of Electrostatic Discharge Damage on page 198
Power Supply in EX2200 Switches on page 18
Power Supply in EX3200 Switches
Power Supply in EX3300 Switches
Power Supply in EX4200 Switches
AC Power Supply in EX4300 Switches
DC Power Supply in EX4300 Switches
AC Power Supply in EX4500 Switches
DC Power Supply in EX4500 Switches
AC Power Supply in EX4550 Switches
DC Power Supply in EX4550 Switches
AC Power Supply in an EX4600 Switch
DC Power Supply in an EX4600 Switch
Copyright © 2015, Juniper Networks, Inc.64
Complete Hardware Guide for EX2200 Ethernet Switches

Table of Contents

Other manuals for Juniper EX2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX2200 and is the answer not in the manual?

Juniper EX2200 Specifications

General IconGeneral
Throughput77 Mpps
MAC address table8000 entries
Jumbo frames supportYes
Number of VLANs1024
Networking standards-
Switch typeManaged
SFP module slots quantity4
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports quantity48
StackableNo
Product colorBlack
Power consumption (typical)100 W
Operating altitude0 - 3048 m
Non-operating altitude0 - 4877 m
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth254 mm
Width441 mm
Height43 mm
Weight3600 g

Related product manuals