Quick Start Guide
EX2200
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 4
Step 3: Keep Going | 6
Step 1: Begin
IN THIS SECTION
Mount the EX2200 on Two Posts of a Rack | 2
Connect Power to the EX2200 | 2
To install and perform initial configuration of a Juniper Networks EX2200 Ethernet Switch, you need:
•
Two mounting brackets and eight mounting screws (provided)
•
Screws to secure the chassis to the rack or cabinet (not provided)
•
Phillips (+) screwdriver, number 2 (not provided)
•
For AC systems—an AC power cord with a plug appropriate for your geographical location and a power cord retainer—both
provided
•
For DC systems—DC power source cables (12–14 AWG—not provided) with ring lugs (Molex 0190700067 or
equivalent—not provided) attached
•
For grounding the switch—a grounding cable (minimum 14 AWG (2 mm²), minimum 90°C wire), a grounding lug (Panduit
LCD6-14BH-L or equivalent), a pair of 10-32x.25-in. screws, and a pair of flat washers—none provided
•
Ethernet cable with an RJ-45 connector attached (provided)
To Next Page
