Juniper EX2200 User Manual

CHAPTER 7
Planning Power Requirements
•
Power Specifications for EX2200 Switches on page 79
•
AC Power Cord Specifications for EX2200 Switches on page 80
Power Specifications for EX2200 Switches
This topic describes the power supply electrical specifications for EX2200 switches.
Table 25 on page 79 provides the AC power supply electrical specifications for EX2200
switches.
Table 26 on page 79 provides the DC power supply electrical specifications for EX2200
switches.
Table 25: AC Power Supply Electrical Specifications for EX2200 Switches
SpecificationItem
100 through 240 VACAC input voltage
50 Hz/60 Hz nominalAC input line frequency
•
7 A at 100 VAC and 2.9 A at 230 VAC (for switches with ports equipped for
PoE)
•
1.8 A at 100 VAC and 0.5 A at 230 VAC (for switches with no ports equipped
for PoE)
AC system current rating
Table 26: DC Power Supply Electrical Specifications for EX2200 Switches
SpecificationItem
36 through 75 VDCDC input voltage
3.5 A maximumDC input current
100 WPower supply output
1 ms minimumOutput holdup time
79Copyright © 2015, Juniper Networks, Inc.

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g