Juniper EX2200 User Manual

Figure 38: Mounting the EX2200-C Switch on a Wall Using Screws
g021159
5. (Optional) Attach the optional cable guard to protect cable connections:
a. Use the 3 truss-head screws toattach the cable guard to the bottom of the chassis.
b. Use the thumbscrews to tighten or loosen the guard to allow you to insert cables.
See Figure 39 on page 108.
Figure 39: Attaching a Cable Guard to an EX2200-C Switch
g021161
6. (Optional) Attach the optional standard cable lock to a security slot on the side of
the switch:
a. Rope the cable to a desk or a rack and set the lock to the unlocked position.
b. Insert the lock into a security slot on your chassis and set the lock to the locked
position. See Figure 40 on page 109.
Copyright © 2015, Juniper Networks, Inc.108
Complete Hardware Guide for EX2200 Ethernet Switches

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g