Juniper EX9208 - User Manual

Quick Start Guide
EX9208
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 7
Step 3: Keep Going | 9
Step 1: Begin
IN THIS SECTION
Install the Mounting Shelf in a Rack | 2
Mount the EX9208 | 3
Connect Power to the Switch | 4
To install and perform initial configuration of a Juniper Networks EX9208 Ethernet Switch, you need:
•
One small mounting shelf and 22 mounting screws (provided)
•
Phillips (+) screwdrivers, numbers 1 and 2 (not provided)
•
7/16-in. (11-mm) torque-controlled driver or socket wrench (not provided)
•
One mechanical lift (optional, not provided)
•
Electrostatic discharge (ESD) wrist strap with cable (provided)
•
2.5-mm flat-blade (–) screwdriver (not provided)
•
Power cord with a plug appropriate for your geographical location for each power supply (not provided)
•
Ethernet cable with an RJ-45 connector attached (provided)

Juniper EX9208 Specifications

General

Brand	Juniper
Model	EX9208
Category	Switch
Language	English

Summary

Step 1: Begin

Install the Mounting Shelf in a Rack

Details the process for installing the mounting shelf hardware into a standard rack.

Mount the EX9208

Provides instructions for physically securing the EX9208 chassis onto the installed mounting shelf.

Connect Power to the Switch

Outlines the steps for connecting the EX9208 switch to AC or DC power sources.

Step 2: Up and Running

Set Parameter Values

Specifies essential console server or PC parameter settings required before initial configuration.

Perform the Initial Configuration

Guides users through the initial software configuration of the EX9208 using the CLI.

Step 3: Keep Going

Safety Warnings Summary

A compilation of critical safety warnings to prevent injury or equipment damage during operation.

Contacting Juniper Networks

Provides the URL for accessing technical support and documentation from Juniper Networks.