If your device is running an earlier release, upgrade to one of these releases and then
to the 10.1 release. For example, to upgrade from Release 9.2R1, first upgrade to
Release 9.2R4 and then to Release 10.1R2.
For additional upgrade and download information, see the JUNOS Software
Administration Guide and the JUNOS Software Migration Guide.
JUNOS Software Release Notes for EX Series Switches
■ New Features in JUNOS Release 10.1 for EX Series Switches on page 186
■ Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series
Switches on page 189
■ Limitations in JUNOS Release 10.1 for EX Series Switches on page 190
■ Outstanding Issues in JUNOS Release 10.1 for EX Series Switches on page 193
■ Resolved Issues in JUNOS Release 10.1 for EX Series Switches on page 196
■ Errata in Documentation for JUNOS Release 10.1 for EX Series
Switches on page 199
■ Upgrade and Downgrade Issues for JUNOS Release 10.1 for EX Series
Switches on page 200
New Features in JUNOS Release 10.1 for EX Series Switches
New features in Release 10.1 of JUNOS Software for EX Series switches are described
in this section.
Not all EX Series software features are supported on all EX Series platforms in the
current release. For a list of all EX Series software features and their platform support,
see EX Series Switch Software Features Overview.
New features are described on the following pages:
■ Hardware on page 187
■ Access Control and Port Security on page 187
■ Bridging, VLANs, and Spanning Trees on page 187
■ Class of Service (CoS) on page 188
■ Infrastructure on page 188
■ Interfaces on page 188
■ Layer 2 and Layer 3 Protocols on page 188
■ Management and RMON on page 188
■ MPLS on page 189
■ Packet Filters on page 189
186 ■ JUNOS Software Release Notes for EX Series Switches
JUNOS 10.1 Software Release Notes
To Next Page
Loading...
Need help?
General
