Layer 2 and Layer 3 Protocols
■
EX Series switches now support the show multicast rpf instance instance-name
command.
■
The iso option is not available in the show pfe route command because it is not
supported on EX Series switches.
Infrastructure
■
On EX Series switches, the sip-server statement in the [edit system services dhcp]
hierarchy is now supported, allowing explicit configuration of SIP server addresses
for DHCP servers.
User Interface and Configuration
■
On EX3200 switches and EX4200 switches, the request system power-off
other-routing-engine and the request system power-off both-routing-engines
commands are disabled.
■
The output of the show chassis hardware command for EX3200 switches and
EX4200 switches has been changed. The Description field in the output now
displays SFP-100-LX40 for the 100Base-LH interface and SFP-100-LH for the
100Base-ZX interface.
■
If you enable PIM on all interfaces using the interface all command, it is not
enabled on the me0 and vme interfaces by default. Therefore you do not need
to explicitly disable PIM on these management interfaces. Previously, enabling
PIM on all interfaces caused it to be enabled on these management interfaces.
Related Topics ■ New Features in JUNOS Release 10.1 for EX Series Switches on page 186
■ Limitations in JUNOS Release 10.1 for EX Series Switches on page 190
■ Outstanding Issues in JUNOS Release 10.1 for EX Series Switches on page 193
■ Resolved Issues in JUNOS Release 10.1 for EX Series Switches on page 196
■ Errata in Documentation for JUNOS Release 10.1 for EX Series Switches on
page 199
■ Upgrade and Downgrade Issues for JUNOS Release 10.1 for EX Series Switches
on page 200
Limitations in JUNOS Release 10.1 for EX Series Switches
This section lists the limitations in JUNOS Release 10.1R3 for EX Series switches.
190 ■ Limitations in JUNOS Release 10.1 for EX Series Switches
JUNOS 10.1 Software Release Notes
To Next Page
Loading...
Need help?
General
