[System Basics Command Reference]
Layer 2 Ethernet Services
■ Modification to the output of the show dhcp (relay or server) binding
commands—The output of the show dhcp server binding summary command,
the show dhcp relay binding summary command, and the show dhcpv6 server
binding command has been modified to include the number of clients in the init
state and the requesting state.
[Subscriber Access]
MPLS Applications
■
MPLS statistics file now optional—The file statement configured at the [edit
protocols mpls statistics] hierarchy level is now optional. You still must configure
the MPLS statistics statement to collect LSP statistics for the MPLS MIBs. Rather
than accessing the LSP statistics in the MPLS statistics file, you can view the
statistics using SNMP instead. This change helps to reduce disk space usage on
the routing engine, especially on routers on which numerous LSPs have been
configured.
[MPLS]
■ NSR tracing flags for MPLS—You can now configure MPLS tracing flags for
nonstop active routing (NSR) synchronization events. This enables you to track
the progress of NSR synchronization between Routing Engines and record these
operations to a log file. To configure, include the flag nsr-synchronization or flag
nsr-synchronization-detail statement at the [edit protocols mpls traceoptions]
hierarchy level. The two statements are not mutually exclusive; you can track
the events at a high level and in detail.
[High Availability, MPLS, Routing Protocols]
46 ■ Changes in Default Behavior and Syntax in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
JUNOS 10.1 Software Release Notes
To Next Page
Loading...
Need help?
General
