20 21
[System Basics Command Reference]
■
Modification to the output of the show interfaces extensive command
output—For IQ2E interfaces, the show interfaces extensive command output no
longer displays the schedulers field, because there is no static scheduler
partitioning of schedulers among different ports in IQ2E.
[Interfaces Command Reference]
■
Enhancement to the show chassis sibs command—The show chassis sibs
command now displays destination errors for SIBS in the Check state. In JUNOS
Release 10.1 and later and JUNOS Release 9.6 and 10.0, the command displays
the number of destination errors for SIBS in the Check state:
user@host> show chassis sibs
Slot State Uptime
0 Empty
1 Empty
2 Check (21 destination errors) 1 day, 1 hour, 32 minutes,
55 seconds
3 Check (0 destination errors) 1 day, 1 hour, 32 minutes,
45 seconds
4 Empty
use "show chassis fabric fpcs" to determine which PFEs have destination
errors
However, for JUNOS Release 9.3 and 9.5, the command only displays the message
destination errors or no destination errors for a SIB that is in the Check state, but
does not display the number of destination errors:
user@host> show chassis sibs
Slot State Uptime
0 Empty
1 Empty
2 Check (destination errors) 1 day, 1 hour, 32 minutes,
55 seconds
3 Check (no destination errors) 1 day, 1 hour, 32 minutes,
45 seconds
4 Empty
use "show chassis fabric fpcs" for more details
In addition, the command also displays a message to use the show chassis fabric
fpcs command for more information about the destination errors.
If there are no SIBs in the Check state, there is no change in the output of this
command.
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers ■ 45
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
To Next Page
Loading...
Need help?
General
