Juniper JUNOS 10.1 - RELEASE NOTES REV 4 User Manual

[Network Interfaces]
■
Commit-time warning messages at the [edit interfaces] hierarchy level are
now system logged—CLI commit-time warnings displayed for configuration at
the [edit interfaces] hierarchy level have been removed and are now logged as
system log messages. This change is applicable to JUNOS Release 10.1R1 and
later, 10.0R2, and 9.3R4. [CLI User Guide]
■ Invalid count of queues—The PD-5-10XGE-SFPP PICs in T Series routers do not
display ingress control queue statistics as output from the show interfaces queue
xe-fpc/pic/port forwarding-class command. However, you can use the following
commands to display the ingress control queue statistics:
■
show interfaces queue both-ingress-egress xe-fpc/pic/port
■
show interfaces queue xe-fpc/pic/port
■
show interfaces queue xe-fpc/pic/port ingress
[Network Interfaces]
■
Support for configuration of a range of interfaces through the interface-range
statement—Enables you to group a range of identical interfaces and apply a
common configuration for the interfaces using a reduced number of configuration
statements. To configure an interface-range group, include the interface-range
statement and substatements at the [edit interfaces] hierarchy level. To view an
interface range group in expanded configuration, use the show | display inheritance
command.
[Network Interfaces, Interfaces Command Reference]
■
Enhancement to the show chassis fabric fpcs command—In JUNOS Release
10.1 and later, the show chassis fabric fpcs command issued on a T640 or T1600
router displays destination errors in addition to link errors. The command output
displays a list of Packet Forwarding Engines that have destination errors, for
those SIBs that are in the Check state. This enhancement is also applicable to
JUNOS Release 9.6 and 10.0. The following sample shows the enhanced output
for this command:
user@host> show chassis fabric fpcs
Fabric management FPC state:
FPC #3
PFE #1
SIB #2
Plane enabled
SIB #3
Link error
Destination error on PFEs 0 1 2 3 4 5
6 7
8 9 10 11 12 13 14 15 16 17 18 19
20 21
SIB #4
Destination error on PFEs 0 1 2 3 4 5
6 7
8 9 10 11 12 13 14 15 16 17 18 19
44 ■ Changes in Default Behavior and Syntax in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
JUNOS 10.1 Software Release Notes

Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Specifications

General

Brand	Juniper
Model	JUNOS 10.1 - RELEASE NOTES REV 4
Category	Software
Language	English