Juniper JUNOS 10.1 - RELEASE NOTES REV 4 User Manual

Command-Line Interface (CLI)
■
On SRX Series devices, the show security monitoring fpc 0 command is now
available.
The output of this CLI command on SRX Series devices differs from previous
implementations on other devices. Note the following sample output:
show security monitoring fpc 0
FPC 0
PIC 0
CPU utilization : 0 %
Memory utilization : 65 %
Current flow session : 0
Max flow session : 131072
NOTE: When SRX Series devices operate in packet mode, flow sessions will not be
created and current flow session will remain zero as shown in the sample output
above. The maximum number of sessions will differ from one device to another. On
SRX3400, SRX3600, SRX5600, AND SRX5800 devices, the output will include two
more lines: SPU current cp session and SPU max cp session.
■ On SRX210 devices with Integrated Convergence Services, TDM configuration
change might interrupt existing TDM calls if any MPIMs are configured. The voice
calls through the MPIM do not work. Run the CLI restart rtmd command after
making a configuration change to the MPIM ports.
■ On SRX210 devices with Integrated Convergence Services, registrations do not
work when PCS is configured and removed thorough the CLI. The dial tone
dissappears when the analog station calls the SIP station. As a workaround, either
run the rtmd restart command or restart the device.
■
On SRX5600 and SRX5800 devices, the set security end-to-end-debug CLI hierarchy
command has been changed to set security datapath-debug.
■ On AX411 Access Points, the possible completions available for the CLI command
set wlan access-point mav0 radio 1 radio-options mode? are changed from previous
implementations.
Now this CLI command displays the possible completions as shown below:
■ Example 1:
user@host# set wlan access-point mav0 radio 1 radio-options mode ?
Possible completions:
5GHz Radio Frequency -5GHz-n
a Radio Frequency -a
an Radio Frequency -an
[edit]
■ Example 2:
Changes In Default Behavior and Syntax in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services
Routers ■ 125
Changes In Default Behavior and Syntax in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers

Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Specifications

General

Brand	Juniper
Model	JUNOS 10.1 - RELEASE NOTES REV 4
Category	Software
Language	English