Juniper JUNOS 10.1 - RELEASE NOTES REV 4 User Manual

the link-protection statement at the [edit interfaces aex aggregated-ether-options
link-protection] hierarchy level. To display the active, primary, and backup link
for an aggregated Ethernet interface, use the operational mode command show
interfaces redundancy aex.
[Class of Service, Network Interfaces]
■ Re-marking of MVPN GRE encapsulation DCSP at ASBR (MX Series routers
with Trio MPC/MIC interfaces)—Enables you to configure DSCP marking for
GRE encapsulated packets that aligns with the service provider core CoS policy
for an MVPN. To configure, include the DSCP rewrite-rule dscp dscp-rule-name
with the values at the [edit class-of-service] hierarchy level and then apply the
rewrite rule to the core-facing multicast interface at the [edit class-of-service
interfaces] hierarchy level.
[Class of Service]
■ PD-5-10XGE-SFPP, 10-port 10-Gigabit Ethernet (Type 4) PIC (T640, T1600,
and TX Matrix routers with G-FPC4, ST-FPC4, and ST-FPC4.1)—Supports a
WAN bandwidth of 100 Gbps in addition to the following features:
■ Intelligent handling of oversubscribed traffic
■ Line rate operation on up to five 10-Gigabit Ethernet ports
■ Tap features, such as flexible encapsulation, source address (SA) MAC
learning, MAC accounting, and MAC policing
■ Stacked virtual LAN (VLAN) tag and VLAN rewrite functionalities
[Network Interfaces, Class of Service, PIC Guide]
■ Intelligent oversubscription services (MX Series with 16-port 10-Gigabit
Ethernet MPC with SFP+)—The 16-port 10-Gigabit Ethernet Modular Port
Concentrator (MPC) is an oversubscribed configuration. Consequently, it is
necessary to protect control traffic over best-effort traffic as soon as packets
enter the line card. To do this, packets entering the line card are assigned a
preclassifier control traffic class according to the header types (such as destination
MAC addresses, and Layer 4 ports) in the packet. The preclassifier provides a
good way to classify and queue important control traffic in a different high-priority
queue from that used for best-effort traffic.
The preclassifier (control or best effort) is assigned prior to packets being accepted
into the initial stream and is used by the line card as an early designation (before
any class-of-service configuration is applied). When oversubscription occurs,
control traffic will be queued separately and should not be subject to any dropped
packets.
The Layer 2 protocols supporting the preclassifier are:
■ 802.1ah
■ 802.1g
■ 802.1x
■ 802.3ad
■ ARP
8 ■ New Features in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
JUNOS 10.1 Software Release Notes

Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Specifications

General

Brand	Juniper
Model	JUNOS 10.1 - RELEASE NOTES REV 4
Category	Software
Language	English