Need help?Do you have a question about the Juniper SRX100 and is the answer not in the manual?
General| Routing protocols | BGP, IS-IS, MPLS, OSPF |
|---|---|
| Switching protocols | VLAN 802.1Q, 802.3ad/LACP, STP |
| Supported network protocols | IPv4, IPv6, CLNS |
| Firewall security | Yes |
| Security algorithms | 3DES, DES |
| Authentication method | RADIUS, RSA SecureID, LDAP |
| VPN support | IPsec VPN |
| Data transfer rate | 0.1 Gbit/s |
| Input voltage | 100 - 240 V |
| Input frequency | 50/60 Hz |
| Heat dissipation | 35 BTU/h |
| Power requirements | 100-240, 50/60 |
| Power over Ethernet (PoE) | No |
| Power consumption (typical) | 30 W |
| Safety | UL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1 |
| Certification | FCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386 |
| Mounting type | Rack mounting |
| Internal memory | 1024 MB |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
Weight and Dimensions| Weight | 1100 g |
|---|---|
| Dimensions (WxDxH) | 216 x 147 x 36 mm |
To Next Page
