Juniper SRX300 - Page 4

How to Set Up Your SRX300 Services Gateway
4
Power On the Device
CAUTION: Before connecting the device to the power supply, attach an
ESD strap to an ESD point and place the other end of the strap around your
bare wrist.
1. Plug the DC connector end of the power cable into the power connector on
the rear of the device.
g000
736
2. Plug the AC adapter end of the power cable into an AC power outlet.
3. Turn on the power to the AC power receptacle.
4. Note the following LED indications. Wait until the STATUS LED is solid green
before proceeding to the next step.
g000
734
LED State
ALARM • Solid amber (noncritical alarm).
• Solid red (critical alarm).
• O (no alarms).
STAT • Solid green (operating normally).
• Solid red (error detected).
PWR • Solid green (receiving power).
• Solid red (power failure).
• O (no power).
HA • Solid green (all HA links are available).
• Solid amber (some HA links are unavailable).
• Solid red (HA links are not functional).
• O (HA is disabled).
Connect the Management Device
1. To configure the device using J-Web (recommended), connect any of the
network ports numbered 0/1 through 0/6 to the Ethernet port on the
management device, using an RJ-45 cable.
g000
737
SRX300
RJ-45 cable
Ethernet port
Ethernet port
NOTE: The ge-0/0/0 and ge-0/0/7 interfaces (ports 0/0 and 0/7)
are WAN interfaces. Do not use these ports for the initial configuration
procedure.