How to restore factory settings on Juniper Gateway if configuration fails?
If configuration fails or you're denied management access to your Juniper Gateway, use the RESET CONFIG button to restore the device to its factory-default configuration or a rescue configuration.
What happens if I press the RESET CONFIG button on my Juniper SRX300 for too long?
Pressing the RESET CONFIG button on the Juniper Gateway for 15 seconds or more deletes all configurations on the device, including the backup configurations and rescue configuration, and loads and commits the factory configuration.
What to do if Juniper Gateway configuration changes don't take effect after reset?
If configuration changes requiring a reboot do not take effect on your Juniper Gateway after resetting the configuration, power off and then power on the device.
What to do if my Juniper Gateway is not receiving power?
If your Juniper Gateway isn't receiving power, first check the AC power cord to ensure it's not damaged. Also, verify that the power socket you're using is working correctly. Finally, make sure the device is receiving an AC input voltage between 100 and 240 VAC.
What happens if my Juniper Gateway overheats?
If the Juniper Gateway temperature is too high due to internal overheating or excessive room temperature, the services gateway will automatically shut down in 4 minutes.
Why is my Juniper Gateway chassis temperature too warm?
If your Juniper Gateway chassis temperature is too warm, it could be due to an internal overheating condition or because the maximum recommended room temperature has been exceeded. Check the room temperature to ensure it's within the recommended range.
What to do if Juniper Gateway boots from an alternate boot device?
If your Juniper Gateway boots from an alternate boot device, there could be several reasons. If you configured your services gateway to boot from an alternative boot device, you can ignore this alarm condition. Otherwise, it could be due to the internal flash memory failing at startup, in which case you should reformat the internal flash memory and install a bootable image. If you didn't configure it and reformatting doesn't help, further assistance is needed.
General| USB 2.0 ports quantity | 1 |
|---|---|
| Connectivity technology | Wired |
| SFP module slots quantity | 2 |
| Ethernet LAN (RJ-45) ports | 6 |
| Internal memory | 4000 MB |
| Flash memory | 8000 MB |
| Storage media type | Flash |
| Power consumption (typical) | 15.4 W |
| Noise level | 0 dB |
| Heat dissipation | 85 BTU/h |
| Concurrent connections | 64000 |
| Mean time between failures (MTBF) | 389820 h |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Storage relative humidity (H-H) | 5 - 95 % |
| Operating relative humidity (H-H) | 10 - 90 % |
| Routing protocols | BGP, CLNS, IS-IS, OSPF, RIP-1, RIP-2 |
| Number of users | 50 user(s) |
| Quality of Service (QoS) support | Yes |
| Firewall throughput | 1000 Mbit/s |
| Mobile VPN IPSec | 250 |
| IPS/IDS throughput | 100 Mbit/s |
| Harmonized System (HS) code | 85176990 |
Weight and Dimensions| Weight | 1980 g |
|---|---|
| Dimensions (WxDxH) | 320.8 x 34.7 x 191 mm |
To Next Page
