Juniper SRX300 - Accessing the CLI on the SRX300 Services Gateway; Configuring the SRX300 Services Gateway Using the CLI

•
Internal zones
•
DMZ
•
Defining security policies and Network Address Translation (NAT) rules
•
Configuring remote access
NOTE: Before applying the configuration changes to the services gateway,
check the connectivity to the services gateway. You might lose connectivity
if you have changed the management zone IP. Click the URL for reconnection
instructions for information on how to reconnect to the device.
After you finish configuring the services gateway with the setup wizard and commit your
configuration, you are redirected to the J-Web interface. Thereafter, whenever you connect
to the services gateway, you are placed in the J-Web interface. You can access the setup
wizard from the J-Web interface and use it to reconfigure your services gateway. To do
so, select Configuration Wizards>Set Up. You can either edit an existing configuration or
create a new configuration.
NOTE: If you elect to create a new configuration, then all the current
configuration in the services gateway will be deleted.
Related
Documentation
Accessing J-Web on the SRX300 Services Gateway on page 62•
• Accessing the CLI on the SRX300 Services Gateway on page 65
• Connecting to the SRX300 Services Gateway from the CLI Remotely on page 66
• Configuring the SRX300 Services Gateway Using the CLI on page 67
• Verifying Settings for the SRX300 Services Gateway on page 69
Accessing the CLI on the SRX300 Services Gateway
To access the CLI on the SRX300 Services Gateway:
1. Connect one end of the Ethernet cable to the serial console port on the services
gateway.
NOTE: Alternately, you can use the USB cable to connect to the mini-USB
console port on the services gateway. To use the mini-USB console port,
you must download a USB driver to the management device from the
SRX300 Software Download page or Silicon Labs page.
2. Connect the other end of the Ethernet cable to the RJ-45 to DB-9 serial port adapter
supplied with your services gateway.
65Copyright © 2016, Juniper Networks, Inc.
Chapter 16: Performing the Initial Configuration