Juniper SRX300 - Preparing the SRX300 Services Gateway for Wall-Mount Installation; Preparing the SRX300 Services Gateway for Desk-Mount Installation

Related
Documentation
Installing the SRX300 Services Gateway in a Rack on page 43•
• Preparing the SRX300 Services Gateway for Wall-Mount Installation on page 40
• Preparing the SRX300 Services Gateway for Desk-Mount Installation on page 40
Preparing the SRX300 Services Gateway for Wall-Mount Installation
You can mount an SRX300 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability. Before mounting the SRX300 Services Gateway on a
wall:
•
Verify that the installation site meets the requirements described in “Site Preparation
Checklist for the SRX300 Services Gateway” on page 14.
•
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see “Unpacking the SRX300 Services Gateway” on page 37.
•
Verify that you have the following parts available in your wall-mounting kit:
•
Wall-mounting brackets
•
Screws
NOTE: The wall-mounting kit is not shipped with the device and must be
ordered separately.
Related
Documentation
Installing the SRX300 Services Gateway on a Wall on page 45•
• Preparing the SRX300 Services Gateway for Rack-Mount Installation on page 39
• Preparing the SRX300 Services Gateway for Desk-Mount Installation on page 40
Preparing the SRX300 Services Gateway for Desk-Mount Installation
You can mount an SRX300 Services Gateway on a desk or any other level surface
horizontally or vertically. The four rubber feet attached to the chassis provide stability.
Before mounting an SRX300 Services Gateway on a desk or level surface:
•
Verify that the installation site meets the requirements described in “Site Preparation
Checklist for the SRX300 Services Gateway” on page 14.
•
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
•
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see “Unpacking the SRX300 Services Gateway” on page 37.
Related
Documentation
Installing the SRX300 Services Gateway on a Desk on page 47•
• Preparing the SRX300 Services Gateway for Rack-Mount Installation on page 39
Copyright © 2016, Juniper Networks, Inc.40
SRX300 Services Gateway Hardware Guide