CHAPTER 9
Installation Overview
•
SRX300 Services Gateway Installation Overview on page 35
•
Required Tools and Parts for Installing the SRX300 Services Gateway on page 36
•
SRX300 Services Gateway Autoinstallation Overview on page 36
SRX300 Services Gateway Installation Overview
After you have prepared the site for installation and unpacked the SRX300 Services
Gateway, you are ready to install the device. It is important to proceed through the
installation process in the following order:
1. Review the safety guidelines explained in “SRX300 Services Gateway General Safety
Guidelines and Warnings” on page 91.
2. Prepare your site for the installation of the services gateway as described in “Site
Preparation Checklist for the SRX300 Services Gateway” on page 14.
3. Prepare the services gateway for installation. See:
•
Preparing the SRX300 Services Gateway for Rack-Mount Installation on page 39
•
Preparing the SRX300 Services Gateway for Wall-Mount Installation on page 40
•
Preparing the SRX300 Services Gateway for Desk-Mount Installation on page 40
4. Install the services gateway. See:
•
Installing the SRX300 Services Gateway in a Rack on page 43
•
Installing the SRX300 Services Gateway on a Wall on page 45
•
Installing the SRX300 Services Gateway on a Desk on page 47
5. Connect the grounding cable as described in “Connecting the SRX300 Services
Gateway Grounding Cable” on page 50.
6. Power on the services gateway as described in “Powering On the SRX300 Services
Gateway” on page 56.
Related
Documentation
SRX300 Services Gateway Autoinstallation Overview on page 36•
• Site Preparation Checklist for the SRX300 Services Gateway on page 14
35Copyright © 2016, Juniper Networks, Inc.