CHAPTER 16
Performing the Initial Configuration
•
SRX300 Services Gateway Software Configuration Overview on page 59
•
Understanding SRX300 Services Gateway Factory-Default Settings on page 59
•
Viewing SRX300 Services Gateway Factory-Default Settings on page 60
•
Accessing J-Web on the SRX300 Services Gateway on page 62
•
Configuring the SRX300 Services Gateway Using the J-Web Setup Wizard on page 63
•
Accessing the CLI on the SRX300 Services Gateway on page 65
•
Connecting to the SRX300 Services Gateway from the CLI Remotely on page 66
•
Configuring the SRX300 Services Gateway Using the CLI on page 67
•
Verifying Settings for the SRX300 Services Gateway on page 69
SRX300 Services Gateway Software Configuration Overview
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled and ready to be configured when the device is powered on. You can
perform the initial software configuration of the services gateway by using the
browser-based setup wizard or by using the command-line interface (CLI).
Before configuring the device, gather the configuration information required to deploy
the device in your network. At a minimum, the setup wizard requires the following
information:
•
Device name
•
Password for the root user
•
Time information for the services gateway location
Related
Documentation
Configuring the SRX300 Services Gateway Using the J-Web Setup Wizard on page 63•
• Configuring the SRX300 Services Gateway Using the CLI on page 67
Understanding SRX300 Services Gateway Factory-Default Settings
Your services gateway comes configured with a factory-default configuration. The default
configuration includes the following security configuration:
59Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
