CHAPTER 12
Installing the SRX300 Services Gateway
in a Rack
•
Installing the SRX300 Services Gateway in a Rack on page 43
•
Installing the SRX300 Services Gateway on a Wall on page 45
•
Installing the SRX300 Services Gateway on a Desk on page 47
Installing the SRX300 Services Gateway in a Rack
You can front-mount the SRX300 Services Gateway in a rack. Many types of racks are
acceptable, including four-post (telco) racks, enclosed cabinets, and open-frame racks.
For more information about the type of rack or cabinet the SRX300 Services Gateway
can be installed in, see “SRX300 Services Gateway Rack Size and Strength Requirements”
on page 23.
NOTE: The rack-mounting kit is not shipped with the device and must be
ordered separately.
NOTE: If you are installing multiple devices in one rack, install the lowest one
first and proceed upward in the rack. Ensure that the rubber feet from the
base of the chassis are removed for rack installation.
To install the device in a rack:
43Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
