How to Set Up Your SRX320 Services Gateway
3
5. Install the second screw in each mounting bracket.
6. Verify that the mounting screws on one side of the rack are aligned with the
mounting screws on the opposite side and that the device is level.
The SRX320 Services Gateway can also be mounted on a desk or a wall. For
details, see the SRX320 Services Gateway Hardware Guide.
NOTE: The mounting kits are not shipped with the device and must be
ordered separately.
Connect the Grounding Cable (Optional)
1. Attach an ESD strap to an ESD point and place the other end of the strap
around your bare wrist.
2. Connect the grounding cable to a proper earth ground.
3. Place the grounding cable lug over the grounding point on the rear of the
chassis.
NOTE: A licensed electrician must attach a cable lug to the grounding
cable. A cable with an incorrectly attached lug can damage the device.
4. Secure the grounding cable lug to the grounding point with the screw.
756
Grounding point
on the chassis
Grounding lug
ounding
rew
Power On the Device
NOTE: Before connecting the device to the power supply, attach an ESD
strap to an ESD point and place the other end of the strap around your
bare wrist.
1. Plug the DC connector end of the power cable into the power connector on
the rear of the device.
2. Plug the AC adapter end of the power cable into an AC power outlet.
3. Turn on the power to the AC power receptacle.